How to judge the processing quality of jewelry?

Jewelry processing is an important part that affects the overall beauty of jewelry. No matter how good the quality of the gem itself is, it will fall short if it encounters rough workmanship. But it is worth noting that most people cannot correctly judge whether the workmanship of this piece of jewelry is good or not. Jewelry processing is an important part of the overall beauty of jewelry. No matter how good the quality of the gem itself is, as long as it encounters rough workmanship It will fall short. However, it is worth noting that most people cannot correctly judge whether the workmanship of this piece of jewelry is good or not, which causes a certain amount of trouble for everyone's purchase. To judge the quality of jewellery, you must start with these points: 　　　　01. There are many ways to set the gemstones firmly, but no matter which setting method is used, no matter how big the gemstone is, make sure that the setting mouth can hold the gemstone safely. , There are no gaps in the contact with the metal, no claws are not attached to the stone, the card position is left empty, and the edge is not pressed to prevent the gem from shaking or accidentally falling off.　　　　02. Whether the metal surface is smooth or not. 　　　　Improper casting, welding and polishing will leave marks on the metal surface. Finely crafted jewellery will not have rough surfaces or uneven edges, but will be smooth and uniform, fine in quality, without chisel marks and burrs. If jewelry has texture and pattern design, it depends on whether they are clear and smooth.　　　　03. Whether there are welding seams or traces in the jewelry. 　　　　 The surface of the jewelry should be bright and uniform, with the same color, and there should be no pores, black spots or dim gloss at the corners and bumps. The welding point must be smooth and free of false welding.　　　　04. Check whether the weight of the ring face and the foot of the ring is appropriate for a well-made ring. The ring face is slightly heavier than the ring foot. 　　　　If the workmanship is not good, the ring will turn and slide towards the fingertips. The way to check is to put the ring on your finger and shake it gently, so that the ring side does not turn to the fingertips.　　　　 The above is the author's summary of the jewelry processing information for you. The information comes from the Internet. If there is anything wrong, please understand. If you need jewelry processing, please pay attention to the official website of jewelry inlay. Jewelry inlay is waiting for your inquiry!