How to make 925 silver by hand

How to make 925 silver jewellery by hand After receiving the customized order from the customer, the beginning process is the plate making. A few years ago, before the 3D modeling software came out on the market, hand-made plates were mainly used, among which hand-made plates also included hand-carved wax plates and hand-made silver plates. These two processes have their own advantages and complement each other. Here is an introduction to these two processes. 1. Hand-carved wax version. It means that the craftsman uses wax carving tools and paraffin to carve the shape according to the requirements of the design drawings, and then uses the lost wax casting method to invert the copper plate or the silver plate. Pay attention to the following points when engraving the wax plate: When making the rough embryo, you should use a file to file the dents and pierce the peaks to make the shape round and smooth. When refilling wax, the soldering iron should not stay in the same position for too long, otherwise the wax embryo will be easily deformed. Undercut the workpiece to reduce the weight and cost of the workpiece. When using the ball needle to remove the excess wax inside the workpiece, the internal caliper should be used to accurately measure the nailing position and the forced setting position to prevent deviation. This method has the advantages of easy modification and less tool loss. The disadvantage is that it is more difficult to make the inner insert of the nail. 2. Hand-made the silver version. It means that the craftsman directly uses the metal of silver to make the silver plate according to the requirements of the customer's design drawings. There are a few things to pay attention to when making the silver jewelry plate: when removing the water line, the position of the water line cannot be cut with pliers; you must use the Zhuo bow; when using the file, the file must move along the contour track or arc of the nozzle position of the workpiece to facilitate Makes the nozzle position smoother; the ring version needs to be checked by hand to check whether it meets the size requirements. If it is too large or too small, it needs to be trimmed. In the process of using the file, if the flat part is encountered, it must be flat and straight. , Is positive, if it is a curved surface, you need to make an arc movement; after the silver plate is finished, you must correct the stone position, if the stone position does not match the stone, you must adjust it. The main advantage of hand-made silver plate is that it is very convenient and of good quality to make the inlay. The above is the hand-made plate of 925 silver jewelry shared by the jewelry factory. If you want to find custom-made silver jewelry processing, you are welcome to visit and inspect, call the hotline: Mr. Wang