How to make a diy sweater chain pendant

How to make a DIY sweater chain pendant-a cute bird-style sweater chain pendant with a cute image of jewelry, made by the method of winding jewelry, how to make your own DIY sweater chain pendant, let the author lead you to learn below . Production materials: round copper wire (1mm and 0.3mm thick), 10mm diameter aquamarine perforated round beads, round hammer and anvil, round nose jewelry pliers, wire cutters, sandpaper sweater chain pendants. Production steps: Step 1: In production Before the bird pendant, first design and draw the wire making sketch. Step 2: Use round-nosed jewelry pliers to bend the 1mm thick copper wire port into a small ring. Step 3: Place the ring on the anvil and use a round hammer to Beat the edge of the ring into a flat. Step 4: Use the ring as a bird pendant necklace ring, and then bend the copper wire into the bird’s head according to the sketch design. Step 5: Bend the front of the head into a bird’s mouth. Step 6: Adjust the angle of the bend into the beak, use pliers to twist the beak 90 degrees. Step 7: Place the twisted beak copper wire ring on the anvil and beat it flat with a round hammer. Step 8: Turn the beak behind the beak. The copper wire is still bent into the bird's abdomen according to the design sketch. Step 9: When bent to the tail, the copper wire is naturally bent into the bird's wings according to the sketch. Step 10: The copper wire bent into the wings is then adjusted into a circular ring. The size of the ring can be embedded with gems. Beat the ring with gems and the round copper wire on the lower abdomen of the bird into a flat shape, and bend the copper wire to the surface of the gem. Step 11: Continue to insert the ring with gems, the bird’s head and abdomen Step 12: Cut off the excess length of the copper wire bent to the surface of the precious feldspar. Step 13: Beat the end of the copper wire on the surface of the gem until it is flat, and sand the end into a circular arc. Step 14: Use 0.3mm The thick copper wire is wound from the back of the bird, and the necklace rings on the back are wound and fixed together. Step 15: Continue to wind, wind the copper wire along the wings and fix the gem ring together. Step 16: Wind the thin copper wire After reaching the small section, insert the gem ball, and pass the thin copper wire through the perforation of the gem ball, and fix the thin copper wire on the ring copper wire opposite the perforation of the ball. Step 17: The copper wire on the opposite ring of the thin copper wire is wound several times and then passed through the small hole of the gem ball to the opposite side of the ring. Step 18: Continue to wind the thin copper wire to the end of the copper wire on the surface of the gem. Step 19: With the lower abdomen The copper wires are twisted and fixed together, and the end is finished, and the production of the bird sweater chain pendant is completed