Jade bracelet size comparison table and measurement method

Today netizens said: I like jade, but I always break it. Up to now, I have broken 5 of them. Is it not suitable for the ring? The author found it incredible that the jade bracelet on the store manager’s wrist had been worn for seven years. The hardness of jade in jade 　　 Today netizens said: I like jade, but it is always broken. Up to now, 5 of them have been broken. Is it not suitable for the ring?　　　　 The author found it incredible. The jade bracelet on the store manager’s wrist has been worn for seven years. The hardness of jade is relatively high in jade, how can it be so fragile, the wrong ring has a great influence on the wearing of jade.　　　　 The following author will popularize the bracelet measurement methods for friends who want to buy jade bracelets: 　　　　1, soft ruler measurement method 　　　　 Press the tip of your thumb to the base of the little finger, be careful not to be too tight or too loose. Use a soft ruler or a thread around the circumference of the widest part of the palm. When measuring, you can measure it tightly if you have a soft hand. If your hand bones are hard, you can measure it to the point where the thread is tightened. Divide the obtained length by 0.314, which is the diameter of the inner ring of your bracelet.　　　　 For example: the left hand measures 16.8cm (168mm), after dividing by 0.314, it can be determined that the bracelet is suitable for wearing a 53.5mm inner ring. It needs to be slightly loose or slightly tight. You can add or subtract 1-2cm from the front and back, which is the actual size of your hand and the size of the bracelet.　　　　 Because the degree of ellipse of the jade imperial concubine bracelet is different, you can wear the imperial concubine bracelet with 54 inner diameter and long side instead of 54 round bracelets. (Under normal circumstances, 1-2mm should be added to facilitate the wearing of the bracelet, and 3-4mm should be added for the elderly and those with large and hard hand joints).　　　　2, the ruler measurement method 　　　　 the palm of the hand is naturally spread out, so that the index finger and the thumb are at a right angle of 90 degrees, align the ruler 0 scale at the 90 degree angle, and measure the widest part of the palm. Compare the measured data with the following table, and simply convert it to know how big a bracelet you can wear!　　　　Parameter description: 　　　　1. Bracelet inner diameter: commonly known in the industry as 'ring mouthAs shown in the figure above; 　　　　 2. Bracelet thickness: Generally measure the thickness of the bracelet strip, the thickness from the inner ring to the outermost ring is the thickness of the bracelet. As shown in the picture above; 　　　　 3. Bracelet width: Generally measure the width of the bracelet strip. The width of the standard round bracelet is the thickness, and the safety bracelet and chaise bracelet are the width of the flat mouth. As shown in FIG.　　　　 The above is the author's summary of the bracelet size comparison table information for you. The information comes from the Internet. If there is anything wrong, please understand. If you need to customize the bracelet, please pay attention to the official website of jewelry inlay. Jewelry inlay is waiting for your inquiry!