Jewelry inlay, processing and customization process

Jewelry inlay craftsmanship began in Western countries. For hundreds of years, generations of craftsmen have inlaid many brilliant jewels. A gemstone wants to be the pride of the fingertips. The hardships experienced are cruel. It is cut and polished until she has a touching figure and luster. Jewelry inlay craftsmanship began in Western countries and have been inlaid by generations of craftsmen for hundreds of years. Many brilliant jewels. A gemstone wants to be the pride of the fingertips. The ordeal it goes through is cruel. It is cut and polished until she has a touching figure and luster.　　　　 mainly the following steps: 　　　　 jewelry designers must have drawing skills, but also have unique design thinking. Only by communicating with customers in the early stage can we serve customers from a professional perspective. The starting version is a high-tech work in the entire processing and production. The starting version is to make the plane design drawings into three-dimensional jewelry samples. The starting version is divided into two categories, one is the silver version and the other is the carving. Wax version. The wax version is faster than the silver version. However, some styles of claw setting or some special styles must be silver version, and the wax version must be poured into a silver version to be molded. The overall effect of the version is not as good as the silver one. The stamping mold is to fill the silver plate with rubber and heat it in the molding machine. After cooling, use the blade to remove the silver plate inside, leaving a built-in model. The average service life of the rubber mold can reach more than 10 years. the above. Inverted mold is to make wax mold into wax tree, put it in a steel cup, pour the liquid mixed with gypsum powder and water into it, wait for the gypsum powder to solidify, put it in the furnace and slowly heat it to make the copper cup The wax inside melts slowly. Take out the steel cup more than ten hours later and pour the molten gold into the copper cup. Generally, 18K needs to be cooled for 30 minutes to take out the semi-finished products inside. PT, about 10 minutes will do. After taking it out, rinse it with a water gun. Some will not be rinsed. Put it in hydrochloric acid, soak for a few minutes, and then rinse it.　　　　 Molding refers to the process of carefully repairing the rough jewelry.　　　　 inlay is to embed one object in another object (such as 18k, 925 silver ring) to fix the two; inlay refers to embedding the object, and embedding refers to the small object clamped in the gap of the large object. Mosaic is mostly used in technical production terms.　　　　 is to set the gemstone to the semi-finished product and the setting method is divided into: ① card setting ② claw setting ③ bezel setting ④ nail setting ⑤ borderless setting.　　　　Polishing: It is to polish the surface of the products that have been mounted with clamps, and prepare for the next step of electro-golding. The main polishing tools are: cloth wheel, wax, flying butterfly.　　　　Finally, QC quality inspection to check the finished product for trachoma, floating gold, and whether the inlaid stones are loose.　　　　 The above is the information about jewelry setting summarized by the author for you. The information comes from the Internet. If there is anything wrong, please understand. If you need to set, please go to the official website of jewelry setting. Jewelry setting is waiting for your inquiry!