Sterling silver jewelry customization process

Commonly used silver jewelry materials are alloys, copper, silver and gold. In addition to the value of jewelry materials, sterling silver jewelry also pays great attention to the design and manufacturing process. If it is not handled properly, the sterling silver jewelry jewelry may not have valuable silver jewelry. Let's take a look at the customization process of sterling silver jewelry customization. Any fine silver jewelry production must start from melting silver. First put the broken silver in a small crucible, use a welding torch to heat the broken silver in the crucible, while heating, put a little borax, borax will dissolve the oxides on the silver surface, make the silver more pure, and help the silver melt quickly. Borax should be added multiple times. The melting point of silver is 960°C. When the silver in the crucible is heated to a high temperature above 960°C, the silver starts to melt. The molten silver is made into silver flakes for use. Pressing silver hammers the molten silver material flat and puts it in a tablet press for tableting. The pressing process should be repeated, one time thinner than the other, and then the silver material is pressed into a silver flake with a thickness of approximately 2 mm. Use scissors to cut the silver sheet into a 1 cm wide rectangle. Anneal the pressed silver flakes. Annealing is to use a welding gun to slowly heat the silver material made of molten silver to a certain temperature and ensure sufficient time. It is used to remove the rigidity of the silver itself, and its purpose is to improve the plasticity and toughness of the silver material and to make the chemical composition of the silver material uniform. Polishing winds the annealed silver piece around the bracelet jewelry, loops it around the bracelet jewelry, and makes a ring according to the size of the finger. Cut off the excess silver material with scissors, and then weld the ring. Place the cooled ring on the bracelet and hit it with a hammer to make it rounder. Grind the inside of the ring with a grinder. Boil the silver. Place the solder ring in alum water and boil the silver. Alum, usually called alum, has a strong adsorption capacity and does not chemically react with silver. It can wash away impurities and make silverware appear whiter. Cooking the ring with heated alum water can remove the impurities remaining on the ring when welding the ring, and it can also dissolve the borax used in the welding to improve the purity of the jewelry. Take out the silver-white bracelet jewelry and polish the surface a second time with a suspended grinding wheel. Next, we need to make some decorations for this bracelet jewelry. We need to use silver wire to make silver wire by pulling the silver wire. Pull out a thin silver bar, and use a file to thin one end of the silver bar. Take out the cable plate. The main purpose of the pull wire board is to pull the silver wire. Place the polished end of the silver bar into the lower end of the cable plate. Use pliers to fix the silver bar on the upper end of the cable plate, and then pull it out firmly. The diameter of the circular hole on the drawing plate continuously decreases. The drawn thread is thin and well proportioned. If you want to pull out the required fine silver wire, you need to repeatedly pass it through holes of different diameters. Fix the ring on the welding plate with a hanging clamp and anneal the silver wire. Solder one end of the silver wire to the middle of the ring, and then wind the silver wire on both sides of the ring. During the winding process of the disc, the silver beads are threaded on the silver wire and wound around the ring. Every silverware design has a certain meaning. The meaning of this work is: the slender silver wire is like a flowing stream, bypassing the small stone barrier and flowing between the fingers. Wrap the silver wire tightly without loosening it. Cut off the excess silver wire with pliers. Use needle-nose pliers to insert the silver wire into the silver bead. And make proper welding to fix it. Put the finished bracelet jewelry into heated alum water to remove impurities. Polishing In the latter step, the bracelet jewelry is repeatedly brushed and polished with a copper wire brush for polishing. After completion, our sterling silver jewelry custom bracelet is ready. Previous page: Precautions for maintenance and cleaning of sterling silver jewelry customization